Most cell phone owners use headphones. It is necessary to listen to music on the road, watch movies on the couch, and talk, of course. Normal earphones with a wire can interfere with your movements. Big headphones with huge speakers sound good, but they are also not comfortable sometimes.
Apple’s headphones are the solution to these problems. AirPods do not have a wire that can snag. They are small and do not cause discomfort when worn. The system of small speakers and the special design allow you to achieve excellent sound. That’s why users love them so much.
During use, every part gets dusty, and headphones are no exception. These need periodic cleaning. But they cannot be cleaned like shoes from street dirt. Cleaning requires more control and a careful approach. The site klymen.com has some recommendations on how to do this
General rules for cleaning your AirPods
You may have one of the AirPods models, such as the AirPods, AirPods Max or AirPods Pro, the EarPods are also included. You can use alcohol wipes on these devices for cleaning. When cleaning, you should only wipe the top surface. Using this for the holes is not recommended.
But then, how do you do a deeper cleaning? There are several ways to do this.
A cotton swab for the ears
This method is recommended by Apple. You can use a soft, lint-free cloth to clean your AirPods and charging case. You can get into hard-to-reach places with a wand with a cotton swab on the end, like the one you use to clean your ears. You should not get the devices wet. They are not waterproof. AirPods Pro do not have water protection either. They are resistant to minor moisture. A direct stream of water or total immersion will disable them.
These cleaning devices are good, but it is not always possible to permanently remove dirt this way.
Dental tool
In cases where the wand with absorbent cotton did not help, you can use another tool. The point is that smooth surfaces are cleaned without difficulty. Mesh and contacts can be difficult to clean. Earwax from the ears is very sticky and can become very sticky. Dust and debris can get very deep into the holes. In such cases, you can take a toothpick and try to remove the dirt with it. Be careful not to damage the mesh inside the earpiece.
Cleaning with Blu-Tack
Blu-Tack is one of the ways to clean devices from dirt that has penetrated deep. These are places where absorbent cotton and toothpicks have failed. In this case, you need to take the Blu-Tack and warm it up with your fingers. Remember this for half a minute until it gets sticky. The glue inside will warm up and start grabbing the small particles.
When you feel that the Blu-Tack is already warm enough, start leaning in and pulling it off. The movements can be impulsive but not too forceful. Be careful with the mesh. Try not to rip it out or push it in deeper.
When all the small particles are gone, you can use a microfiber cloth to remove what has come to the surface but is still on the device.
Cleaning of silicone seals
AirPods Pro headphones have special silicone tips. This is to make the devices fit more snugly in your ears. When cleaning this model, you can remove the silicone pads and rinse them under running water. The headphones cannot be washed in running water.
Install the silicone tips after they have dried completely. Dust and lint will stick more strongly to wet surfaces.
General tips for cleaning all AirPods models
The cleaning process should not be done quickly. Control every movement you make.
Strongly stuck dirt can be loosened with antiseptic or alcohol.
Dampen a lint-free, absorbent cotton or cloth with alcohol and blot the soiled area. This will make the dirt wet, but the alcohol will dry quickly and do no harm.
Pay attention to the headphone case. This also needs cleaning.
No matter what model of headphones you’re cleaning, don’t use compressed air. This can break them, especially the meshes and loudspeakers.
